Home > News > Content

How Is The Conveyor Belt Tested?

Jun 21, 2017

How is the Conveyor Belt tested?
 1. From the source to prevent the break, to strengthen the quality of coal Conveyor Belt control, increase the decontamination equipment, to remove impurities, reduce the number of magazines and more coal, in recent years with the improvement of coal quality i,

Cracked Conveyor Belt greatly reduced the phenomenon;
     2. The addition of fracture detection device, in the shortest possible time test results, alarm and shutdown, due to belt tear is caused by a variety of factors, can not completely avoid the Conveyor Belt fracture, the recent application of the defense

Tearing device and inspection device is mainly tearing test device, generally located in the blanking point, composed of sensors and controllers, the sensor installed in the Conveyor Belt or chute, the controller installed in the machine side or room, when

Debris after tearing the Conveyor Belt, penetrate the Conveyor Belt debris or material extrusion sensor, the sensor signal to the controller, the controller sends an alarm signal and shut down, such devices have many forms, the principle is similar;
     3. Strengthen the management of machinery and equipment to improve the Conveyor Belt inspection and inspection efforts to prevent the liner and other sharp objects off;
     4. Improve the belt conveyor structure, by reducing the drop point drop, increase the buffer equipment, fine material first in the bulk material falling, etc., reduce the impact of material slowdown, reduce the magazine into the Conveyor Belt

     5. The use of detectable tearing industrial Conveyor Belt, in the product with a closed loop with the sensor, the detector installed in the easy to tear parts, the detector connected to the controller, the normal operation, the sensor through

Through the monitor, send a pulse, cut off the sensor coil, the sensor through the detector, the detection of its stop pulse, the controller accepted, the alarm signal and stop;
     6. The use of anti-tear heat-resistant Conveyor Belt and can test the rubber wide belt, the port is rarely used, part of the mine used, tear-resistant Conveyor Belt to the vertical steel frame material, in the band body to add lateral reinforcement as anti Tear layer, the structure of the layer is divided into two kinds: one is hanging plastic mesh; the other is the horizontal rope, the cover layer with high strength, high flexibility, good wear resistance of the compound, different purposes of the plastic Strong level of strength.